Exploring Mixtures and their Separation
How mixtures are classified and separated: homogeneous and heterogeneous mixtures, solutions and their concentration as a percentage, solubility and solubility curves, crystallisation, distillation, paper chromatography, separating immiscible liquids, sublimation, alloys, suspensions, centrifugation, coagulation, colloids and the Tyndall effect.
25 questions on this chapter. Tap an answer to check it straight away. Each answer is explained.
1Which of these is a homogeneous mixture?
Vinegar is acetic acid dissolved in water: a solution, the same throughout.
2In a solution of sugar in water, water is the
The solvent is the substance in which the solute (sugar) dissolves.
315 g of salt is dissolved in 85 g of water. The concentration of the solution is
Mass of solution = 15 g + 85 g = 100 g, so 15 g100 g × 100 = 15 % m/m.
4A saline drip is 0.9 % m/v sodium chloride. How much salt is in 500 mL of it?
0.9100 × 500 = 4.5 g.
5A bottle of hand sanitiser contains 210 mL of alcohol in 300 mL of solution. Its concentration is
210 mL300 mL × 100 = 70 % v/v.
6A solution that cannot dissolve any more solute at that temperature is called
A saturated solution holds the largest amount of solute it can at that temperature.
7As the temperature of water rises, the solubility of a gas such as carbon dioxide in it usually
Gases dissolve less in warm liquids, which is why a warm fizzy drink goes flat sooner.
8A saturated solution has 110 g of a salt in 100 g of water at 60 °C. Its solubility at 20 °C is 32 g per 100 g of water. On cooling to 20 °C, the mass of crystals formed is
110 g − 32 g = 78 g of the salt can no longer stay dissolved.
9Crystallisation is better than evaporation for purifying copper sulphate because
The impurities stay dissolved in the leftover liquid, so the crystals that form are pure.
10Slow cooling of a hot saturated solution gives
The particles have time to arrange themselves neatly, so the crystals grow large.
11Simple distillation can separate two miscible liquids whose boiling points differ by at least about
For smaller differences, fractional distillation is used.
12In a distillation set-up, cold water enters the condenser at the
Water enters at the lower end and leaves at the upper end, so the jacket stays full of cold water.
13Acetone (boiling point 56 °C) and water are distilled. Which collects first in the receiver?
The liquid with the lower boiling point vaporises first.
14Petrol, kerosene and diesel are obtained from crude oil by
Their boiling points are fairly close, so they are separated in a fractionating column.
15In paper chromatography, the line on which the sample is spotted is drawn with a pencil because
An ink line would dissolve and run with the solvent.
16In paper chromatography, the solvent level must be
If the spot were under the solvent, the sample would dissolve away into it.
17A separating funnel is used to separate
Kerosene and water are immiscible and have different densities, so they form two layers.
18In a separating funnel holding oil and water, the water forms the lower layer because it is
The denser liquid sinks to the bottom.
19Which of these sublimes on heating?
Camphor changes directly from solid to vapour; so do naphthalene and ammonium chloride.
20The change of a vapour directly into a solid, without becoming a liquid, is called
Deposition is the reverse of sublimation.
21Brass is
Brass is an alloy, about 80% copper and 20% zinc, and alloys are homogeneous mixtures.
22Plasma is separated from blood cells by
Spinning throws the heavier cells to the bottom, leaving plasma on top.
23Alum is added to muddy water to
Alum is a coagulant: the clumps settle and the water can be decanted or filtered.
24Which mixture is a colloid?
Milk has particles 1 nm to 1000 nm across that stay dispersed and scatter light.
25The path of a light beam is NOT visible when it passes through
A true solution has particles too small to scatter light, so it shows no Tyndall effect.
Answered 0 of 25Score 0