Electricity
How electric charges move through a circuit, what controls the current, and how electrical energy turns into heat.
22 questions on this chapter. Tap an answer to check it straight away. Each answer is explained.
1What is the SI unit of electric current?
Current is measured in amperes (A). One ampere is one coulomb of charge flowing per second.2360 C of charge flows through a wire in 2 minutes. What is the current?
Change the time to seconds first: 2 minutes = 120 s. ThenI=Qt=360 C120 s=3 A3How is an ammeter joined in a circuit?
All the current must pass through an ammeter, so it is joined in series.4In which direction does conventional current flow through the outside circuit?
Conventional current flows from the positive terminal to the negative terminal. Electrons flow the other way.5The potential difference between two points is 1 V when…
Potential difference is work done per unit charge, so 1 V means 1 J of work for every 1 C of charge.6How much work is done in moving 5 C of charge across a potential difference of 6 V?
Work = potential difference × charge = 6 V × 5 C = 30 J.7In a circuit diagram, what does a dot where two wires meet show?
A dot means the wires are connected. Without a dot, the wires only cross.8Which of these has a very high resistance?
A voltmeter has a very high resistance, so it takes almost no current from the circuit it is joined to.9A 6 V battery drives a current of 0.5 A through a resistor. What is its resistance?
R=VI=6 V0.5 A=12 Ω10The potential difference across a resistor is doubled, at the same temperature. What happens to the current?
By Ohm’s law, current is directly proportional to potential difference, so doubling one doubles the other.11Two wires are made of the same metal and have the same length. Wire P has twice the area of cross-section of wire Q. Compared with Q, the resistance of P is…
Resistance is inversely proportional to the area of cross-section, so twice the area gives half the resistance.12What is the SI unit of resistivity?
Since ρ = RAl, its unit is Ω × m2m, which is the ohm metre (Ω m).13Why is the heating element of an electric iron made of nichrome and not copper?
An alloy such as nichrome has a high resistivity, and it does not oxidise (burn) easily, even when red hot.14Resistors of 4 Ω, 6 Ω and 10 Ω are joined in series. What is their equivalent resistance?
In series, the resistances simply add.Rs=4 Ω + 6 Ω + 10 Ω=20 Ω15Two 10 Ω resistors are joined in parallel. What is their equivalent resistance?
1Rp=110 Ω + 110 Ω=210 Ω=15 ΩRp=5 ΩTwo equal resistors in parallel have half the resistance of one of them.
16Why are the appliances in a house joined in parallel?
In parallel, every appliance gets the full 220 V supply, and each one can be switched on or off without affecting the others.17The current through a resistor is doubled, while its resistance and the time stay the same. The heat produced becomes…
Heat is proportional to the square of the current. Doubling the current gives 22 = 4 times as much heat.18A current of 2 A flows through a 5 Ω resistor for 10 s. How much heat is produced?
H=I2Rt=(2 A)2 × 5 Ω × 10 s=200 J19How is a fuse joined in a circuit?
A fuse is joined in series, so that all the current through the appliance also passes through the fuse.20An electric heater is rated 220 V, 1100 W. What current does it draw?
I=PV=1100 W220 V=5 A21How many joules make 1 kilowatt hour?
1 kWh=1000 W × 3600 s=3.6 × 106 J22A 100 W bulb is used for 10 hours. How much electrical energy does it use?
Change 100 W into 0.1 kW first.E=Pt=0.1 kW × 10 h=1 kWh
Answered 0 of 22Score 0