Chapter 12 · Physics

Magnetic Effects of Electric Current

How an electric current makes a magnetic field, the field lines of a bar magnet, a straight wire, a loop and a solenoid, the right-hand thumb rule, electromagnets, the force on a current in a magnetic field and Fleming’s left-hand rule, and how the electric circuits in our homes are wired and kept safe.

Step-by-step answers to all 22 questions in this chapter of the NCERT textbook: the in-text questions after each section, and the exercises at the end. Each question is given exactly as it appears in the book.

In-text questions

12.1 Magnetic field and field lines

  1. Q1
    Why does a compass needle get deflected when brought near a bar magnet?

    Answer

    • A compass needle is itself a small bar magnet, free to turn.
    • The bar magnet has a magnetic field round it, which exerts forces on the poles of the needle: like poles repel and unlike poles attract.
    • These forces turn the needle until it lines up with the magnet’s field. So the needle is deflected.

In-text questions

12.2 Magnetic field lines

  1. Q1
    Draw magnetic field lines around a bar magnet.

    Answer

    Magnetic field lines of a bar magnet. Outside the magnet they come out of the north pole and curve round into the south pole; inside the magnet they run from the south pole to the north pole, so every line is a closed curve. The lines are crowded near the poles, where the field is strongest, and spread out far from the magnet. No two lines cross.SNInside the magnet: S to NCrowded near the poles: strongFar apart: weaker field
    Field lines of a bar magnet. Outside the magnet they go from the north pole to the south pole; inside, from the south pole to the north pole.

    The lines come out of the north pole and go into the south pole, they are crowded near the poles (stronger field) and no two lines cross.

  2. Q2
    List the properties of magnetic field lines.

    Answer

    1. Outside a magnet, field lines go from the north pole to the south pole; inside the magnet, from the south pole to the north pole.
    2. So they are closed curves.
    3. Where the field lines are closer together, the field is stronger; where they are far apart, it is weaker.
    4. No two field lines cross each other.
    5. The direction of the field at a point is along the field line (the way the north pole of a compass needle points there).
  3. Q3
    Why don’t two magnetic field lines intersect each other?

    Answer

    • The field line through a point gives the direction of the magnetic field at that point.
    • If two field lines crossed, the field at the crossing point would have two directions.
    • A compass needle placed there would then have to point in two directions at once, which is not possible. So two field lines never intersect.

In-text questions

12.2 Circular loop and solenoid

  1. Q1
    Consider a circular loop of wire lying in the plane of the table. Let the current pass through the loop clockwise. Apply the right-hand rule to find out the direction of the magnetic field inside and outside the loop.

    Answer

    A circular loop lying flat on a table, seen from above, with the current flowing clockwise. Inside the loop the magnetic field points into the table (crosses); outside the loop it points out of the table (dots).Current: clockwise(seen from above)Inside: field intothe table (down)Outside: field out ofthe table (up)
    The loop seen from above. Crosses: field into the table. Dots: field out of the table.
    • Hold any part of the loop in your right hand with the thumb along the clockwise current. The fingers curl downwards on the inner side of the wire and upwards on the outer side.
    • Every part of the loop gives the same result. So inside the loop, the field is perpendicular to the table, pointing into it (downwards).
    • Outside the loop, the field points out of the table (upwards).
  2. Q2
    The magnetic field in a given region is uniform. Draw a diagram to represent it.

    Answer

    (a) A uniform magnetic field is drawn as parallel, equally spaced straight lines, all pointing the same way. (b) A field that is not uniform: the lines get closer together towards the right, where the field is stronger.(a) Uniform field(b) Non-uniform field
    (a) A uniform field. (b) For comparison, a field that is not uniform.

    A uniform magnetic field is shown by parallel, equally spaced straight lines, all with arrows in the same direction, as in (a). The field has the same strength and direction everywhere in the region.

  3. Q3
    Choose the correct option.The magnetic field inside a long straight solenoid-carrying current(a) is zero.(b) decreases as we move towards its end.(c) increases as we move towards its end.(d) is the same at all points.

    Answer

    (d) is the same at all points.

    The field lines inside a long solenoid are parallel straight lines, so the field is uniform.

In-text questions

12.3 Force on a current-carrying conductor in a magnetic field

  1. Q1
    Which of the following property of a proton can change while it moves freely in a magnetic field? (There may be more than one correct answer.)(a) mass(b) speed(c) velocity(d) momentum

    Answer

    (c) velocity and (d) momentum

    • A moving proton is like a current, so the magnetic field exerts a force on it at right angles to its motion.
    • This force changes the direction of motion. So the velocity, and the momentum (mass × velocity), change.
    • The force does not speed the proton up or slow it down, so its speed stays the same. Its mass does not change.
  2. Q2
    In Activity 12.7, how do we think the displacement of rod AB will be affected if (i) current in rod AB is increased; (ii) a stronger horse-shoe magnet is used; and (iii) length of the rod AB is increased?

    Answer

    The displacement depends on the force on the rod, and the force is larger for a larger current, a stronger field and a greater length of rod in the field.

    • (i) Current increased: the force increases, so the displacement increases.
    • (ii) Stronger magnet: the field is stronger, so the force and the displacement increase.
    • (iii) Longer rod: more of the rod is in the field, so the force and the displacement increase.
  3. Q3
    A positively-charged particle (alpha-particle) projected towards west is deflected towards north by a magnetic field. The direction of magnetic field is(a) towards south(b) towards east(c) downward(d) upward

    Answer

    (d) upward

    • A positive charge moving west is a current towards the west. The force on it is towards the north.
    • Fleming’s left-hand rule: point the second finger west (current) and the thumb north (force). The first finger then points vertically upwards: this is the direction of the field.
    Seen from above: an alpha particle moving west is pushed towards the north. By Fleming’s left-hand rule, with the current towards the west and the force towards the north, the magnetic field must point upwards, out of the page.Moving westForce: north+Seen from aboveField upwardsCurrent: west(same as the motionof a + charge)NEW
    Seen from above: current west, force north, so the field is upwards (out of the page).

In-text questions

12.4 Domestic electric circuits

  1. Q1
    Name two safety measures commonly used in electric circuits and appliances.

    Answer

    • Electric fuse: a wire of low melting point in series with the live wire. It melts and breaks the circuit when the current becomes too large (short circuit or overloading).
    • Earthing: the metal body of an appliance is joined to the earth wire. Any leaking current goes safely to the earth, so the user does not get a severe shock.
  2. Q2
    An electric oven of 2 kW power rating is operated in a domestic electric circuit (220 V) that has a current rating of 5 A. What result do you expect? Explain.

    Answer

    Current drawn by the oven, with P = 2 kW = 2000 W and V = 220 V:

    I=PV=2000 W220 V≈9.1 A

    The oven needs about 9.1 A, which is more than the 5 A rating of the circuit. The circuit is overloaded. The fuse in the circuit melts (Joule heating) and cuts off the supply, so the oven stops working. Without a proper fuse, the wires could overheat and catch fire. The oven should be used on a 15 A circuit.

  3. Q3
    What precaution should be taken to avoid the overloading of domestic electric circuits?

    Answer

    • Do not connect too many appliances to a single socket, or use them all at the same time on one circuit.
    • Run high-power appliances (geysers, heaters, ovens) only on the 15 A circuit.
    • Use a fuse of the correct rating in every circuit.

End of chapter

Exercises

  1. Q1
    Which of the following correctly describes the magnetic field near a long straight wire?(a) The field consists of straight lines perpendicular to the wire.(b) The field consists of straight lines parallel to the wire.(c) The field consists of radial lines originating from the wire.(d) The field consists of concentric circles centred on the wire.

    Answer

    (d) The field consists of concentric circles centred on the wire.

    The field lines round a straight current-carrying wire are concentric circles in planes at right angles to the wire.

  2. Q2
    At the time of short circuit, the current in the circuit(a) reduces substantially.(b) does not change.(c) increases heavily.(d) vary continuously.

    Answer

    (c) increases heavily.

    In a short circuit the live and neutral wires touch, the resistance becomes almost zero, and the current rises suddenly.

  3. Q3
    State whether the following statements are true or false.(a) The field at the centre of a long circular coil carrying current will be parallel straight lines.(b) A wire with a green insulation is usually the live wire of an electric supply.

    Answer

    (a) True. Every part of the coil makes the field point the same way at its centre, where the field lines are parallel straight lines.

    (b) False. The wire with green insulation is the earth wire. The live wire usually has red insulation.

  4. Q4
    List two methods of producing magnetic fields.

    Answer

    • Using a permanent magnet, such as a bar magnet or a horseshoe magnet.
    • Passing an electric current through a conductor: a straight wire, a circular coil or a solenoid. A solenoid with a soft iron core (an electromagnet) gives a strong field.
  5. Q5
    When is the force experienced by a current–carrying conductor placed in a magnetic field largest?

    Answer

    The force is largest when the direction of the current is at right angles (perpendicular) to the direction of the magnetic field.

  6. Q6
    Imagine that you are sitting in a chamber with your back to one wall. An electron beam, moving horizontally from back wall towards the front wall, is deflected by a strong magnetic field to your right side. What is the direction of magnetic field?

    Answer

    The chamber seen from above. The electron beam moves from the back wall towards the front wall, so the current flows the other way, towards the back. The beam is pushed to the right. By Fleming’s left-hand rule the magnetic field points vertically downwards (into the page, crosses).Front wallBack wall (you sit here)Electron beamForce: right−Seen from aboveField downwardsElectrons move tothe front, so thecurrent flows tothe back wall
    Seen from above: current towards the back wall, force to the right, so the field is downwards.
    • Electrons move from the back wall to the front wall, so the current is from the front wall towards the back wall.
    • The force is to your right.
    • By Fleming’s left-hand rule, with the second finger towards the back wall and the thumb to the right, the first finger points vertically downwards.

    The magnetic field is vertically downwards.

  7. Q7
    State the rule to determine the direction of a (i) magnetic field produced around a straight conductor-carrying current, (ii) force experienced by a current-carrying straight conductor placed in a magnetic field which is perpendicular to it, and (iii) current induced in a coil due to its rotation in a magnetic field.

    Answer

    (i) Right-hand thumb rule: hold the conductor in the right hand with the thumb pointing along the current; the fingers wrap round the conductor in the direction of the magnetic field lines.

    (ii) Fleming’s left-hand rule: stretch the thumb, first finger and second finger of the left hand at right angles to each other. If the first finger points along the field and the second finger along the current, the thumb points along the force (motion) on the conductor.

    (iii) Fleming’s right-hand rule: stretch the thumb, first finger and second finger of the right hand at right angles to each other. If the thumb points along the motion of the conductor and the first finger along the field, the second finger points along the induced current.

  8. Q8
    When does an electric short circuit occur?

    Answer

    • A short circuit occurs when the live wire and the neutral wire come into direct contact.
    • This happens when the insulation of the wires is damaged or there is a fault in an appliance.
    • The resistance of the circuit becomes almost zero, so the current increases suddenly to a very large value.
  9. Q9
    What is the function of an earth wire? Why is it necessary to earth metallic appliances?

    Answer

    Function: the earth wire (green insulation) is joined to a metal plate deep in the earth. It provides a low-resistance conducting path for any current that leaks to the metal body of an appliance, taking it safely to the earth.

    Why metallic appliances are earthed: if the live wire touches the metal body (for example, through damaged insulation), the body could be at a high potential and a person touching it would get a severe shock. When the body is earthed, the leaking current flows to the earth and the body stays at the potential of the earth, so the user does not get a severe shock. The large current also usually melts the fuse.

    Earthing. The metal body of an appliance is joined by the green earth wire to a metal plate buried in the ground. If a fault lets the live wire touch the body, the current flows through the low-resistance earth wire into the ground instead of through a person; the body stays at the potential of the earth, and the large current usually blows the fuse.FuseLiveNeutralMetal bodyEarth wireLarge currentto earthMetal plate in the earthFault: live wire touches the body
    A fault current flows safely to the earth through the earth wire.
Revising for the board exam?Get the Chapter 12 revision PDF: quick notes, 20 new board-pattern questions and full answers, for ₹49.